ARTICLES · Hardware

Hardware

Hardware development and electronics

3 articles

ESP32-S3Before You Buy: ESP32-S3 Suffixes, Flash, PSRAM and Ballpark Prices in CNY (with a C3 Comparison)
ESP32-C3PSRAMFlashdev board selectionESP-IDF

Before You Buy: ESP32-S3 Suffixes, Flash, PSRAM and Ballpark Prices in CNY (with a C3 Comparison)

Suffixes like N4, N8R2 and N16R8 say exactly two things: the number after N is Flash, the number after R is PSRAM. This guide puts five common boards' capacities and ballpark prices (in Chinese yuan) on one table, and explains how to choose.

Read More
CH32V307Conquering the CH32V307 on Mac from Scratch: From 'a pile of Windows viruses' to 'the LED blinks and the serial port talks' — a pitfall diary
PlatformIOWCH-LinkRISC-V microcontrollerCH32V macOS developmentWCHembedded macOS

Conquering the CH32V307 on Mac from Scratch: From 'a pile of Windows viruses' to 'the LED blinks and the serial port talks' — a pitfall diary

Building a CH32V307 dev environment on Mac from scratch, only to find PlatformIO's platform hands you a pile of Windows .exe files? This article is a faithful, blow-by-blow record of the real debugging session: manually swapping in a native macOS RISC-V toolchain, clearing the Gatekeeper quarantine, getting the on-board WCH-Link to flash, all the way down to the real root cause behind 'compile and flash both succeed, the serial port prints, but the LED flat-out won't light' — the on-board LED isn't even wired to the MCU at the factory. Every command and error here was actually run; all 10 gotchas I hit are laid out in full, as a heads-up for anyone coming over from Arduino/ESP.

Read More
ESP-IDF installInstalling ESP-IDF v6.0.2 on macOS (From a `brew install` Error to VSCode Finally Seeing Your Setup)
ESP-IDF macOSEIMESP32-S3VSCode setup not foundESP-IDF configuration

Installing ESP-IDF v6.0.2 on macOS (From a `brew install` Error to VSCode Finally Seeing Your Setup)

ESP-IDF installs cleanly from the command line, but the VSCode extension stubbornly insists 'setup not found'? This is a literal walkthrough of my own debugging session: installing `eim` via Homebrew, pulling ESP-IDF v6.0.2 with EIM, scrubbing Windows leftovers out of the project, and finally digging out the real reason the extension can't see your setup—a config key written to the wrong scope. Every command and error below comes from an actual run, so when you hit the same wall you can paste them straight into search.

Read More